Estate Swing Manuel d'instructions télécharger pdf (Page 8)

E-S 1000D Series Instruction Manual

Standard System Overview and Safety Zones

1.3

The system displayed below is a recommended standard system. Other approved accessories

can be installed. Photo sensors and a flashing light indicating gate movement is recommend-

ed for safety purposes.

1,2 Estate Swing Operator • 3 Photocells (not included) • 4 Control board • 5 N/A • 6 Push but-

ton opening device (not included) • 7 Receiver extension (not included)• 8 12Vdc flashing

lamp (not included) • 9 Positive stop (not included) • 10 Charging Control

Notes:

1) When laying electrical cables, use appropriate rigid and/or flexible tube

2) Do not run any wires in the same conduit as110 AC power that may be in the area. This will cause

danger of electrocution.

Important: Preliminary Checks

To ensure safety and an efficiently operating automated system, make sure the following conditions are

observed.

 The gate and post must be suitable for being automated. Check that the structure is sufficiently

strong and rigid, and its dimensions and weights conform to those indicated on page 1.

 Make sure the gates move smoothly without any irregular friction during entire travel.

 Make sure the hinges are in good condition. Ball bearing hinges are necessary for gates weighing

over 200 lbs. or over 10’ in length.

 Make sure the gate is plumb and level.

 The gate post must be secured in the ground with concrete. This will prevent alteration of align-

ments and leveling during installation and during cycles.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Pas de commentaire

Estate Swing Manuel d'instructions Page 8