Estate Swing Manuel d'utilisateur télécharger pdf (Page 7)

Initial Setup

Administrator must initially be a cell phone, after programming you can switch the ad-

ministrator to a land line if you would like that phone to be the first call from the intercom.

Send the following 3 SMS Commands:

FIRST:

*TEL1#1112223333

Replace 1112223333 with the administrator

cell phone.

Wait for the text back from the unit, the text will be:

TEL1=1112223333

__________________________________________________________________________________

SECOD:

*AY?#1

Wait for the text back from the unit, the text will be:

AY-O

__________________________________________________________________________________

THIRD:

*TEL?#1

Wait for the text back from the unit, the text will be:

TEL-O

ALL CAPS MUST BE USED WHE

SEDIG THE UIT TEXT

MESSAGES.

If you do not get a text response from the unit try:

• Turning the ON/OFF switch off and then back on, this will reconnect it to the cel-

lular network.

• Checking the diagnostics display and be sure all the indications from the previous

page are on.

• Checking your phones security settings to make sure it shows a caller id when

used.

• Checking your SIM card to be sure it is a GSM format SIM card and that it has

phone and text minutes available and it is activated.

• Do a full unit reset: turn the ON/OFF switch off and unplug the incoming power

and battery. Have a helper hold down the CALL button on the intercom door sta-

tion. While holding the CALL button reapply power and turn the ON/OFF switch

to on. Wait for the diagnostics display to show OK.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Pas de commentaire

Estate Swing Manuel d'utilisateur Page 7