Estate Swing Manuel d'instructions télécharger pdf (Page 14)

E-S 1000D Series Instruction Manual

There are 4 factors to keep in mind when finding the setback mounting:

1) The (A) measurement is perpendicular from the gate in the CLOSED position.

2) There must be clearance for your gate opener to attach to the gate in the closed position. This is most

commonly an issue on columns. Re-positioning of the hinges or Push-To-Open operation may be required

to achieve clearance.

3) The brackets do not and must not move after installation.

4) The "L" shape brackets can be mounted anywhere on the post or column. They can be mounted on a

separate post or fence as well. The only factor of importance is that when mounting of the brackets is

done the hole in the boomerang bracket that the gate opener mounts on matches the setback on this

page.

It is best to C-Clamp brackets on and test arm movement clearance before permanently attaching

them.

Variations to the ideal setback can be made, so long as the total is less than the combined measure-

ments for the desired opening arc and the motor body is more than 2 inches away from the gate in both

the open and closed position. (setback variations significantly reduces the length and weight capacity of

the operator)

IMPORTANT: Determining Correct Setback

2.3

Below are 2 common examples of setback mountings. These are not the only options

for mounting.

A B Sum a

4 ¾” 5 ¼” 10 110°

5 ¼” 5 ¼” 10 ½ 100°

5 ½” 5 ½” 11 90°

Use one of the rows

to the right:

To determine the position of the gate mounting bracket

(above is for the post mounting bracket) refer to step 13 in

the section “Installation of operator”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 56 57

Pas de commentaire

Estate Swing Manuel d'instructions Page 14