
E-S 1000D Series Instruction Manual
Accessories Wiring
6.0
The manufacturer instructions that come with your accessory should have markings for wires
or terminals to connect to the gate opener. Please look for terminals named below in the
instructions for the accessory.
Keypads, Receivers:
Normally Open (NO) or Input (INP) or Relay of entry device = COM terminal of PUSH block
on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device = PUSH1 terminal of PUSH
block on gate opener control board.
NOTE: If the power for the accessory shares a Ground wire/terminal with the relay – Do Not
power that accessory off this control board (example: WKP-P keypad). Instead power that
device with batteries.
12V Power positive (+) or (12V) or (PWR) of entry device = +12V terminal of PHOTO block
on gate opener control board.
12V Power Negative (-) or (GND) or (PWR) of entry device = GND terminal of PHOTO
block on gate opener control board.
Push Button, Intercoms:
Normally Open (NO) or Input (INP) or Relay of entry device = COM terminal of PUSH block
on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device = PUSH1 terminal of PUSH
block on gate opener control board.
Push buttons do not require power and Intercoms draw too much power to power from the
gate opener.
Exit Wand/Sensor, Exit Loop Detector, Exit Device:
Normally Open (NO) or Input (INP) or Relay of exit device = COM terminal of PUSH block
on gate opener control board.
Common (COM) or Ground (GND) or Relay of exit device = PUSH2 terminal of PUSH block
on gate opener control board.
12V Power positive (+) or (12V) or (PWR) of exit device = +12V terminal of PHOTO block on
gate opener control board.
12V Power Negative (-) or (GND) or (PWR) or Shield wire of exit device = GND terminal of
PHOTO block on gate opener control board.
Commentaires sur ces manuels