Estate Swing Manuel d'instructions télécharger pdf (Page 29)

E-S 1000D Series Instruction Manual

Control Box & Running Wires

3.3

Control Box Mounting:

 The control box can be mounted on a post or fence line.

 If you have a dual operator set up, make sure it is located within 45’ of the slave motor.

 Allow at least 3 feet of clearance off the ground.

Wiring:

• Protect incoming wires with strain reliefs (not included)

Dual Operation Junction Box:

You will need the following items for this installation:

• Second Junction Box

• Screws

• PVC Conduit

1) Set aside the junction box cover and screws.

2) Drill two holes in the bottom of the junction box

large enough to fit the cables.

3) Mount the junction box within 5 feet of slave opera-

tor.

The junction box can be mounted on a post or a

fence line. Allow at least 3 feet of clearance off the

ground.

4) Insert operator cable and extension cable into the

holes in the bottom of the junction box, and seal with

caulk.

*You may also use a watertight connector and con-

nector nut to secure the cables. Found at your local

hardware store.

6) Insert wires from extension cable and operator ca-

ble into the terminal block connector as seen to the

right.

7) The terminal block may be kept loose or fastened

inside of the junction box.

8) Install and secure cover.

See next page for instructions on running wire under

the driveway.

TIP: If junction box is located in a high mois-

ture area, apply petroleum jelly on to the

terminal block to protect from moisture.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 56 57

Pas de commentaire

Estate Swing Manuel d'instructions Page 29