Estate Swing Manuel d'instructions télécharger pdf (Page 12)

IMPORTANT: Determining Correct Setback

E-S 500 / 502 Classic Series Instruction Manual

2.6

PUSH TO OPEN - This operation is commonly used if you driveway slopes up after the

gate, preventing it from swinging in. This means the gate operator is mounted on the

inside of the property and pushes your gate out away from the property.

To the right are 2 common

examples of setback mountings.

These are not the only options for

mounting.

There a 3 factors to keep in mind when

finding the setback mounting:

1) The measurements must be correct

from the center of the hinge of the gate

to the center of the hole on the mounting

bracket.

2) There must be clearance for you

opener to attach to your gate in the

open position.

3) The brackets do not move or pivot

after mounting, if you can achieve the

setback and clearance then bracket

position is inconsequential.

It is best to C-Clamp brackets on and test

arm movement clearance before

permanently attaching them.

To determine the position of the gate

mounting bracket (above is for the post

mounting bracket) refer to step 6 in the

section “Installation of operator - PTO”

A B Sum

6" 8 ½" 14

110

7½" 9" 16 ½ 100°

9 ½" 9 ½" 19 90°

Variations to the ideal setback can be made, so long as the total is less than the combined

measurements for the desired opening arc and the motor body is more than 2 inches away from the

gate in both the open and closed position. (setback variations significantly reduces the length and

weight capacity of the operator)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Pas de commentaire

Estate Swing Manuel d'instructions Page 12