Estate Swing Manuel d'instructions télécharger pdf (Page 6)

Standard System Overview and Safety Zones

IMPORTANT: Preliminary Checks

E-S 500 / 502 Classic Series Instruction Manual

1.3

The system display to the below is a recommended standard system. Other approved

accessories can be installed. Photo sensors and a flashing light indicating gate

movement is recommended for safety purposes.

1,2 Estate Swing Operator • 3 Photocells (not included) • 4 Control board • 5 N/A

6 Push button opening device (not included) • 7 Receiver extension (not included) • 8

24Vdc flashing lamp (not included) • 9 Positive stop (not included) • 10 AC transformer

To ensure safety and an efficiently operating automated system, make sure the

following conditions are observed.

• The gate and post must be suitable for being automated. Check that the structure

is sufficiently strong and rigid, and its dimensions and weights conform to those

indicated on page 1.

• Make sure the leaves move smoothly without any irregular friction during entire

travel.

• Make sure the hinges are in good condition. Ball bearing hinges are ideal for gates

weighing over 200 lbs. or over 10’ in length.

• Make sure the gate is plumb and level.

• The fence post must be secured in the ground with concrete. This will prevent

alteration of alignments and leveling during installation and during cycles.

Notes: 1) When laying electrical cables, use appropriate rigid and/or flexible tube

2) Do not run any wires in the same conduit as110 AC power that may be in the

area. This will cause danger of electrocution.

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Pas de commentaire

Estate Swing Manuel d'instructions Page 6