Estate Swing Manuel d'instructions télécharger pdf (Page 27)

Control Board Overview

E-S 500 / 502 Classic Series Instruction Manual

5.5

CAUTION! Do not run 110V AC power direct to the

board. This will cause permanent damage to both

boards and void your warranty. Caution!

Gate Opener reactions to signals:

PUSH2 (PUSH 2 terminal and PUSH 2 button):

Details:

• Will activate gate with momentary contact (momentary contact between PUSH2

and V+).

• Controls both leaves in 2 leaf mode (Dip switch 2 in the ON position)..

• Only opens the gate, never closes it.

• Pause time is able to be re-set indefinitely if this terminal is continuously closed

through a non-momentary contact (a connection between PUSH2 and V+ that is

not released) Then the time will be reset and held until the connection between

PUSH2 and V+ is released - then it will count down the pause time and reclose.

• Ideal for exit wand or exit loop.

Operational Sequence for terminal with autoclose ON (Dip switch 1 in on

position):

1. In closed position - momentary contact will open gates.

2. When opening - momentary contact will have no effect.

3. When stopped mid cycle from PUSH 1 or the Receiver - momentary

contact will open the gate.

4. When open with auto-reclose on - momentary contact will re-set pause

time and will start counting again after release of momentary contact. Closed

contact will continually re-set pause time and start counting down to reclose again

after contact is released.

5. When pause time countdown is stopped in open from a momentary contact of

PUSH 1 or the Receiver - momentary contact will have no effect.

6. When closing - momentary contact will re-open the gate.

Operational Sequence for terminal with autoclose OFF (Dip switch 1 in off

position):

1. In closed position - momentary contact will open gates.

2. When opening - momentary contact will have no effect.

3. When stopped mid cycle - momentary contact will open the gate.

4. When open with auto-reclose off - momentary contact will have no effect.

5. When closing - momentary contact will re-open the gate.

PUSH 1 and PUSH 2 – these terminals can hold as many normally open connections as

needed, they will be wired in parallel. They are used for keypads, push buttons, universal

receivers, etc.

1 2 ... 22 23 24 25 26 27 28 29 30

Pas de commentaire

Estate Swing Manuel d'instructions Page 27