Estate Swing Manuel d'instructions télécharger pdf (Page 15)

Troubleshooting

E-S 500 / 502 Classic Series Instruction Manual

5.2

The gate opener is not stopping on the limit switches:

• Remove all pre-installed jumpers from the limit switch terminals that have limits

going to them. The slave gate terminals come pre-jumped for single operation, if

you are using a dual system pay particular attention to this detail and remove the

jumpers when you put your limit switches in.

• The limits are wired incorrectly—be sure that you are following the correct wiring

diagram for pull to open or push to open.

• Check setback— if setback is incorrect it will limit how far the gate will move per

inch of stroke length.

One or both arms are not moving:

• Check to be sure wiring color pattern matches the installation (Example: push to

open wiring for a push to open installation) - If the limits or motor are wiring

opposite the installation the board will believe it is closed or open when it is

actually the opposite and the arms will never move.

• Check the limit wires are correctly in the terminal blocks. The terminal blocks

come with the terminal clamps closed - however when the terminal clamps are

closed there is a small space below them one could mistake as place to insert a

wire. If this is done then conductivity of the connection will never be reached.

• Push or pull on the gate - if it moves the gears are disengaged and the gate is

in manual release mode.

General fix for user to understand operation.

Unlock the gate opener arm and move it to the half way position. Change the run

time to a low number (example: 2). Run the operator repeatedly.

The operator should run one direction for a 2 count and then the other for a 2

count. After you feel you have it following the run time correctly and swinging

level and easily, then start incrementally lengthening the run time.

Eventually the run time will allow the operator arm to reach both limit switches

and your setup is complete.

Single gate - Arm retracts and extends in a jerky manner:

The jumpers are not in place on LIMIT 2—all three need to be jumped together.

Dual gate - Only one arm moves:

• If one arm reaches a limit before the other arm moves, that other arm will never

move. In other words, second arm must move before first hits limit.

• If the device you are using to activate the gate is wired into PUSH 2 that only

opens leaf 1.

• Check your dual settings - if the dip switch is changed to dual with the power on

the setting will not take effect, turn the power off and then back on to have the

dual dip switch take effect. NOTE: If one leaf of a dual gate ever reaches its end

limit before the other leaf starts moving, the leaf that hasn’t started moving will not

begin: correct this by cycling the gates again and let it travel the full stroke or

decrease the delay between leafs. The options are 0-9 seconds delay.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Estate Swing Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte Estate Swing