Estate Swing Manuel d'instructions télécharger pdf (Page 28)

Control Board Overview

E-S 500 / 502 Classic Series Instruction Manual

5.6

CAUTION! Do not run 110V AC power direct to the

board. This will cause permanent damage to both

boards and void your warranty. Caution!

Lamp

Terminal:

Sends pulses of 24VDC during opening and closing –

to be used with a 24VDC lamp.

E_Lock:

Sends a pulse (length of time determined by P6

parameter) of 24VDC for a solenoid gate lock during

opening.

A second 1 second pulse of power will be sent after

the closed limit switch is reach to assist in relocking

the gate lock.

Magnetic gate lock must be powered separately

and this terminal can be used to activate a relay that

cuts power to the magnetic lock at the beginning of

a cycle.

V+/

Photocell/

GND:

Provides 12V to be used with a photocell for gate

safety. The photocell terminal is a Normally Closed

connection – it must be jumped to GND when not

being used.

The power output on this terminal is very minimal, do

not exceed one accessory or 300 milliamps.

Do not attach accessories until after you have the gate

opener limit switches and parameters set up and the gate

opener functioning properly by remote.

1 2 ... 23 24 25 26 27 28 29 30

Pas de commentaire

Estate Swing Manuel d'instructions Page 28